Plastic Anisotropy In Sheet Metal Forming

From the results of the finite element analysis it is shown that puckering behavior of sheet metal is largely affected by plastic anisotropy.

Plastic anisotropy in sheet metal forming. Memorandumului 28 400114 cluj napoca romania. Planar anisotropy if by performing experiments on the sheet it is found that the measured r value is unchanged with orientation the sheet is said to have planar anisotropy. The type of plastic anisotropy usually desired in sheet metal forming is that the sheet is isotropic in the plane and has an increased strength in the thickness direction which is nor mally referred to as normal anisotropy. This scalar quantity is used extensively as an indicator of the formability of recrystallized low carbon steel sheets.

The computer simulation of the sheet metal forming processes needs a quantitative description of the plastic anisotropy by the yield locus. Numerical analysis is carried out in order to investigate the influence of plastic anisotropy on sheet metal forming processes such as stretching and deep drawing. A general elasto plastic finite element formulation based on incremental deformation theory for planar anisotropy and its application to sheet metal forming int. The lankford coefficient also called lankford value r value or plastic strain ratio is a measure of the plastic anisotropy of a rolled sheet metal.

If r 1 then the sheet is of course isotropic 9 22 2015 39 40. It is shown that the neglect of the anisotropy in the simulations leads to inaccurate results. The analysis is based on the deformation theory and hill s theory of plastic anisotropy. The numerical results are compared to experiments.

Advances in anisotropy of plastic behaviour and formability of sheet metals. Finally the effect of plastic anisotropy on the puckering behavior in the spherical cup deep drawing process is investigated. For the first time testing methods for plastic anisotropy of round bars and tubes are included. A stress points forming contours of plastic work of aluminum alloy sheet 6016 o compared with the yield loci.

Plasticity 15 1999 35 67. Anisotropic one as accurately as possible 1 11. Plast 15 1 1999 pp. A large chapter is devoted to formability testing both for bulk metal and sheet metal forming.