Panzer4 Turret Roof Armor Thickness

The upper superstructure frontal armor was 80 mm at a 50 angle the sides were 40 mm at a 19 angle the rear armor was 30 mm and the top was 20 mm.

Panzer4 turret roof armor thickness. The last 68 ausf. The hull s armor was largely the same as the ausf g with the differences lying on the hull s roof. D were produced with 50 mm. Submarine which made up far left side of turret face looking from inside turret out of gun port with d shaped cutout making up about half of.

10 mm 0 39 in. 10 mm 0 39 in schürzen. When sloped it reduces the penetrating power of bullets and solid shot as after penetrating each plate projectiles tend to tumble deflect deform or disintegrate. 5 mm 0 20 in to 8 mm 0 31 in turret front.

30 mm 1 2 in turret roof. Armor on the lower hull front. Having more armour might help but adding proper safety features to cope with a catastrophic hit would probably be a better strategy. The thickness of the front plates on the turret and the weapon mantlet was 50 mm and this thickness was not increased in future upgrades.

The front turret armor was 16 mm at a 10 angle while the sides and rear were 14 5 mm at 25 angle and the top was 10 mm at 83 90 angle. The maximum thickness holed at jutland was 9 inches. 50 mm 2 0 in turret side and rear. Improving the machines protective armor during production was a slow process and by november only about half of the tanks included the reinforced armor.

Preference given to data from jentz. Test of 26 66cm class a main armament turret face port plate originally for ijn shinano the third japanese yamato class super battleship converted into an aircraft carrier instead and sunk on its way to final fitting out yard by a u s. The commander s cupola had all around 14 5 mm of armor with the two hatch doors being 8 mm thick. The engine compartment design and armor were unchanged with 20 mm all around and 10 mm of top armor.

Pig s head style mantlet. The side armor was 30 mm the rear 20 mm and the bottom was 10 mm. Spaced armor that is not sloped is generally designed to provide protection from explosive. Increasing the turret front armour to about 10 inches would probably suffice.

J were produced without face hardened armor and the superstructure roof was thickened to 16 mm. Armor with two or more plates spaced a distance apart falls under the category of spaced armour spaced armour can be sloped or unsloped. Hull roof and floor.